-
Configure DHCP on CISCO Router
In this tutorial, You will learn how to configure DHCP on Cisco Router. This lab is intended to be a simple tutorial for beginners. No other parameters are configured related to terminal…
-
Basic Network Configuration – Packet Tracer
This is the beginning of Packet Tracer Tutorial series in which different labs will be posted from beginner to intermediate and finally, more complicated level. Basic Network Configuration using Packet Tracer 7.0…
-
How To Configure Backup Static Route In Packet Tracer
This tutorial will show you, how to configure backup static route in packet tracer. Example lab shows the backup route in between R1 and R2. Let’s configure the Static Route on R1…
-
Inter VLAN Routing
As per CISCO definition, “A VLAN is a group of devices on one or more LANs that are configured to communicate as if they were attached to the same wire, when in…
-
STP Interface States
Each Layer 2 interface on a switch using spanning tree exists in one of these states Blocking Listening Learning Forwarding Disabled Understanding STP Interface States Blocking: Interfaces in this mode do not participate in frame…
-
Spanning Tree Protocol – STP
Spanning Tree Protocol is a management protocol used by Layer 2 switches to prevent the frame looping within switched topology when multiple redundant links are connected. Multiple active paths among switches causes frame looping,…
-
EIGRP Hello Packet, Hello Interval and the Hold Time
What is EIGRP Hello Packet, Hello Interval and the Hold Time? Hello Packets: EIGRP uses non-periodic updates to update the routing information about the paths that have been changed. This information…
-
IP helper-address command in CISCO
Ever wondered in an environment where there are multiple VLANs are configured, how does the user devices get the IP Address and how do the devices know which DHCP Server to contact…
-
IEEE Ethernet Cable Standards CISCO
IEEE (Institute of Electrical and Electronics Engineers) defines ethernet cable standards under 802.3 standards. These standards specify the Physical Layer and the data link layer specifications. Below are the standards defined by IEEE…
-
CISCO Switch Security Matters! Setting up Passwords on a CISCO Switch
Ever wondered what if your switch falls under wrong hands, either a corrupt user in your Data Centre or a remote user(hacker)? Well this is where you would bet on securing your CISCO devices.…
Recent Comments